Hermle B300 5 axis help!
Registered
Hermle B300 5 axis help!
Hi All,
We have a Hermle B300 with a Heidenhain iTNC 530 control, it will not make a tool change in MDI after start-up any advice? or am I missing something?
Thanks in advance
H Similar Threads:
Last edited by Bada Bing; 01-05-2012 at 11:39 PM .
Member
HI,
I need more info on the problem before solving this.
- does it work on automatic mode?
- any error messages?
- what happened, was it working fine earlier?
Jukka
Registered
Hermle B300 5 axis help!
Tags for this Thread
Posting Permissions
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
Forum Rules